Luminex FLEXMAP 3D User Manual User Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 86
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
FIGURE 5.
Fuse Caution Label
The following voltage label appears on the back of the FLEXMAP 3D
®
instrument. It displays
the FLEXMAP 3D
®
serial number, model number, power requirements, and manufacturer’s
information.
FIGURE 6.
Serial Number and Voltage Label
Heat
The heater plate, used to warm the heater block of the XY platform, can be heated between
35°C and 60°C.
WARNING: The heater plate of the Luminex
®
FLEXMAP 3D
®
XY platform
may be hot and can cause personal injury if touched. Do not
touch the heater plate.
Decontamination Procedure
Occasions may arise when it becomes necessary to decontaminate the entire
Luminex
®
FLEXMAP 3D
®
instrument, for example, prior to shipping. If you must decontaminate the
instrument, sanitize the accessible surfaces and the internal fluidics system. This is
particularly important when biohazardous samples have been run.
For research use only. Not for use in diagnostic procedures.
Safety
7
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 85 86

Comments to this Manuals

No comments