Luminex FLEXMAP 3D User Manual User Manual download pdf (Page 45)

Cleaning the Ventilation Filters

Each filter has at least one imprinted arrow on its metal frame. This arrow indicates the

direction of the air flow. Filters should be installed so that the arrows are at the correct

locations and point in the correct direction.

To clean the Luminex

FLEXMAP 3D

ventilation filters:

Turn off the FLEXMAP 3D

instrument and unplug the power cord.

2. Remove the XY cover by gently grasping its ventilation holes and pulling it straight out.

3. Slide clamps off the silver filter inside the cover and remove the filter.

NOTE: For filter location, reference the "Ventilation Filter on XY Platform"

image below.

4. Open the front doors. Slide clamps off the left and right silver door filters and remove the

filters.

NOTE: For clamp location, reference the "Ventilation Filters inside Doors"

image below.

5. Clean the filters with a vacuum or with deionized water.

Stand the filters upright to air dry.

CAUTION: Filters must be completely dry prior to reinstallation.

7. Reinstall filters. The arrows on the door filters should point to the inside of the door. The

arrow on the XY filter should point up.

For research use only. Not for use in diagnostic procedures.

Maintenance and Cleaning

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 85 86

No comments

Luminex FLEXMAP 3D User Manual User Manual Page 45